Hardware

How do you charge HyperPulse?

Via the Micro-USB-B port on the short edge of the patch. Plug into any 5V USB-A wall plug or USB-A laptop port. 90 minutes from empty to full. For team-scale charging, the Team Case 22 dock charges 22 sensors simultaneously.

Solo charging

Pop the sensor out of the patch (lift one corner, slide it out). Plug the included 1-foot Micro-USB cable into the sensor and any USB-A 5V/2A source. Charging LED lights red, turns green at full.

Team charging

Team Case 22 dock holds 22 sensors vertically in TPU slots. Drop a sensor in (USB-end-down), the dock's right-angle Micro-USB plug seats by gravity. Per-slot LED shows status. Master bar pulses green when all 22 are charged.

Charge time

Empty to full: 90 minutes single-sensor on a 5V/2A source. Slightly longer on Team Case 22 (sharing power across 22 ports) — typically 2 hours for a fully drained team.

Power source options

Wall plug, laptop port, USB power bank, car USB-A. The Team Case 22 uses 4× Anker 6-port USB-A chargers (60W each, 24 ports total).

Try HyperPulse™

$129 launch sensor. designed for rule review; approval varies by sport, state, league, event, school, and official. 12 sports supported.

Claim My $129 Sensor →